Installation
The detailed installation instructions can be downloaded in our Download section (Instructions)
For additional customer installation reports please go to our LSD@Show section.
Pre-installation check list:
- Battery disconnected
- Front bumper removal
- Front fender removal
- Disconnect the wire harness between chassis and door
- Disassemble the door.
Mounting the ground plate to a pillar and door:
- Modify the fender according to instructions (cutting the edge)
- Modify the door, depending on the vehicle model (drilling an additional hole, cutting the edge)
- Mount the ground plate to the mounting points of the chassis
- Mount the swing arm to the mounting points of the dismantled door
Assembly and Alignment:
- Mount the door to the vehicle and completely close it
- Mount the swing arm loose to the ground plate and adjust it by moving the door
- Adjust the bolt for closing the door
- Hang (mount) the gas shock on the mount point of the swing arm, secure it with the kit supplied security ring
- Close the door and let the door lock and set in place
- Adjust opening angle and limitation
- Run the wires and fix them with wire straps
- Mount the fender to the vehicle, pivot the door carefully up and make sure there is sufficient clearance on the fender, A-pillar and hood
